Pin configuration change after save/close/open

A forums to allow bugs and problems with Flowcode v7 to be reported and resolved.

Moderator: Benj

stefan.erni
Posts: 502
Joined: Fri Aug 19, 2016 2:09 pm
Location: switzerland
Has thanked: 159 times
Been thanked: 143 times
Contact:

Pin configuration change after save/close/open

Postby stefan.erni » Tue Feb 06, 2018 4:23 pm

Hi Ben

If I configurate the UART with the corect Pin for RX = F2 and TX= F8. After save and close/open again, the Pin for RX/TX change to A14/A15.
Thats confusing....
And I dont understand why RX/TX remable is showing

b4save.PNG
b4save.PNG (19.79 KiB) Viewed 761 times


save_and_later.PNG
save_and_later.PNG (18.2 KiB) Viewed 761 times


Flowcode_test_2018_sdcard1.fcfx
(45.03 KiB) Downloaded 50 times

User avatar
Benj
Matrix Staff
Posts: 14216
Joined: Mon Oct 16, 2006 10:48 am
Location: Matrix TS Ltd
Has thanked: 4355 times
Been thanked: 4095 times
Contact:

Re: Pin configuration change after save/close/open

Postby Benj » Thu Feb 08, 2018 12:59 pm

Hello Stefan,

Many thanks for letting us know.

I've had a bit of a go with the component and now think that I've solved the problem for you.

Simply copy the attached into your "Flowcode 7/Components" directory and restart Flowcode.

RS232.fcpx
(14.96 KiB) Downloaded 49 times


Let us know how you get on.

stefan.erni
Posts: 502
Joined: Fri Aug 19, 2016 2:09 pm
Location: switzerland
Has thanked: 159 times
Been thanked: 143 times
Contact:

Re: Pin configuration change after save/close/open

Postby stefan.erni » Thu Feb 08, 2018 1:23 pm

Hi Ben

Perfect. it's ok now.
Another idea of the serialport....
Can you support in the selector
230400Bd
460800Bd
921600Bd

And can you include in the software uart a very simple IRQ like in the hardware uart?