EEPROM

A forums to allow resolved bugs and problems with Flowcode v7 to be stored and marked as resolved.

Moderator: Benj

Post Reply
User avatar
Osta
Posts: 159
Joined: Tue Jul 05, 2016 9:42 am
Contact:

EEPROM

Post by Osta »

Do not read EEPROM ..
Attachments
MD_7.fcfx
(5.66 KiB) Downloaded 132 times

User avatar
PaulNe
Posts: 27
Joined: Fri Jul 05, 2013 8:36 am
Contact:

Re: EEPROM

Post by PaulNe »

Hi Osta,

I do not have an 18F45K80 to test with, however, I changed the uC to a 16F1937 and using our EB006 with an LED board on PORTD. For me it is working perfect.

I added an EEPROM write to the code, to write my own value, and then verify by reading it back. It works perfectly in both hardware and simulation.

Hope this helps?

Paul
Attachments
MD_7_MatrixEdit.fcfx
(7.09 KiB) Downloaded 134 times

User avatar
Osta
Posts: 159
Joined: Tue Jul 05, 2016 9:42 am
Contact:

Re: EEPROM

Post by Osta »

Hi Paul!
Yes, with this processor, it works!
And with my not working .....
Attachments
EEPROM_OK.jpg
(414.31 KiB) Downloaded 993 times

User avatar
Osta
Posts: 159
Joined: Tue Jul 05, 2016 9:42 am
Contact:

Re: EEPROM

Post by Osta »

Hi paul!
Put update FC7_Latest_Files_040816.
EEPROM began to work !!!
But only a comma.
Through the point enters an incorrect value.
Regards Slava.
Attachments
MD_7.fcfx
(6.27 KiB) Downloaded 126 times

User avatar
medelec35
Valued Contributor
Valued Contributor
Posts: 9015
Joined: Sat May 05, 2007 2:27 pm
Location: Northamptonshire, UK
Contact:

Re: EEPROM

Post by medelec35 »

Hi Slava,
Have you read this post?
After updating EEPROM may fully work for you?

Martin
Martin

User avatar
Osta
Posts: 159
Joined: Tue Jul 05, 2016 9:42 am
Contact:

Re: EEPROM

Post by Osta »

Hi! Thanks Martin! I received the update, EEPROM works !!!!
Regards Slava.

Post Reply