ghost or oscilloscope

For questions and comments on programming in general. And for any items that don't fit into the forums below.

Moderators: Benj, Mods

stefan.erni
Posts: 521
Joined: Fri Aug 19, 2016 2:09 pm
Location: switzerland
Has thanked: 161 times
Been thanked: 151 times
Contact:

ghost or oscilloscope

Postby stefan.erni » Wed May 29, 2019 8:18 am

Hi Ben

On my board(Pic32MZ) I have a spi port and a interrupt pin. Both is working but not as I expect.
I add a small connector to all this pins, so there are avaible for an additional hardware.

Is it possible to use ghost or the oscilloscope to control it?
Can I use my own hardware for it? With a second PIC or a second board?
Or the eblock would help?
BL0032 E-blocks2 dsPIC Programmer

regards

Stefan