ghost or oscilloscope

For questions and comments on programming in general. And for any items that don't fit into the forums below.

Moderators: Benj, Mods

Post Reply
stefan.erni
Valued Contributor
Valued Contributor
Posts: 654
Joined: Fri Aug 19, 2016 2:09 pm
Location: switzerland
Has thanked: 182 times
Been thanked: 179 times
Contact:

ghost or oscilloscope

Post by stefan.erni »

Hi Ben

On my board(Pic32MZ) I have a spi port and a interrupt pin. Both is working but not as I expect.
I add a small connector to all this pins, so there are avaible for an additional hardware.

Is it possible to use ghost or the oscilloscope to control it?
Can I use my own hardware for it? With a second PIC or a second board?
Or the eblock would help?
BL0032 E-blocks2 dsPIC Programmer
regards

Stefan

Post Reply