Flash Arduino with RX from UART connected??
Posted: Mon Jun 10, 2019 12:51 am
This is something that I wanted to ask earlier.
I have these Chinese Arduino clones, with ch340 chips.
If I use the hardware UART, I can't flash the Arduino while the RX is connected to a device..
I need to disconnect the RX pin before I can flash the chip.
Is there a way that I can flash it without disconnect the RX pin?
Thanks!
I have these Chinese Arduino clones, with ch340 chips.
If I use the hardware UART, I can't flash the Arduino while the RX is connected to a device..
I need to disconnect the RX pin before I can flash the chip.
Is there a way that I can flash it without disconnect the RX pin?
Thanks!