Which download software to use?

For questions and comments on programming in general. And for any items that don't fit into the forums below.

Moderators: Benj, Mods

Post Reply
ROSELJR
Posts: 1
Joined: Wed Sep 22, 2021 3:20 am

Which download software to use?

Post by ROSELJR »

When AT89S52 uses the serial port (with USB to serial cable) to download the program, which download software is used?
STC MCU has download programs corresponding to each MCU on its official website, such as STC_ISP_V488. What is the use of AT89S52? My laptop does not have a parallel port.
Introduction of AT89S52: https://www.utmel.com/components/at89s5 ... eet?id=600

EtsDriver
Posts: 444
Joined: Tue Apr 15, 2014 4:19 pm
Location: Kajaani, Finland
Has thanked: 345 times
Been thanked: 227 times
Contact:

Re: Which download software to use?

Post by EtsDriver »

We use Atmel Flip 2.4.4 to load software into AT89C series MCU's. Might still be available somewhere in the Microchip site still. Program is ancient and has its quirks.
2.4.6 was not working correctly for us for some reason.

The AT89 series has bootloader that is inside the chip from factory.
Ill just keep the good work up!

Post Reply