CAL UART comms stops if the baud rate is updated
Posted: Tue May 30, 2017 3:34 pm
Hi Ben,
I am using a 32MX270F256B and when using the CAL UART, if the baud rate is updated the comms will stop. If the update baud icon is disabled the comms works fine. I have attached the test program that i have been using.
I have also installed the patches you have created that takes care of all the timing and peripheral issues too.
Thanks
Zane
I am using a 32MX270F256B and when using the CAL UART, if the baud rate is updated the comms will stop. If the update baud icon is disabled the comms works fine. I have attached the test program that i have been using.
I have also installed the patches you have created that takes care of all the timing and peripheral issues too.
Thanks
Zane