16f18325 clock selection

For Flowcode users to discuss projects, flowcharts, and any other issues related to Flowcode 8.

Moderator: Benj

Post Reply
davidkilshaw
Posts: 18
Joined: Thu Dec 20, 2012 12:31 pm
Has thanked: 2 times
Contact:

16f18325 clock selection

Post by davidkilshaw »

A few weeks ago i had discussions on here with Benj regarding I2c and the outcome was the pins had not been configured correctly for the 16f18325

On a different topic but the same IC

I have set the clock source under the configure window of project options to "HFINTOSC 32MHZ"

reading the datasheet for the device it seems that this clock is programmable for clock speed.

When i go to the General options tab and select a speed there is no difference that occurs on the clock speed.

Is this the correct way of doing this or am i missing a trick

Thanks

Dave Kilshaw

kersing
Valued Contributor
Valued Contributor
Posts: 2045
Joined: Wed Aug 27, 2008 10:31 pm
Location: Netherlands
Has thanked: 553 times
Been thanked: 1081 times
Contact:

Re: 16f18325 clock selection

Post by kersing »

The speed in the general settings is used to calculate timing, baudrates etc. Not to program the chip to run on a different speed. You will need to use a C code icon with the appropriate code for that to happen.
“Integrity is doing the right thing, even when no one is watching.”

― C.S. Lewis

Post Reply