Hi,
Im trying to down load to an arduino mega a program that did work under FC7. The programme will not compile to hex or further download and an error message (attached) is generated. If I delete the CAN macro components, then the programme downloads no problem. I've tried deleting and re-installing the CAN from the current FC8 comms list but the problem is till there. Any help please?
Regards,
Chris
CAN componant macro not working
Moderator: Benj
-
Chris_MIRA
- Posts: 186
- Joined: Wed Jan 23, 2013 3:43 pm
- Has thanked: 2 times
- Been thanked: 21 times
- Contact:
CAN componant macro not working
- Attachments
-
- VIM MEGA Interface.fcfx
- (42.22 KiB) Downloaded 162 times
-
- FC8 Error message.png
- (440.91 KiB) Downloaded 509 times
-
medelec35
- Matrix Staff
- Posts: 9520
- Joined: Sat May 05, 2007 2:27 pm
- Location: Northamptonshire, UK
- Has thanked: 2585 times
- Been thanked: 3815 times
- Contact:
Re: CAN componant macro not working
As this post relates to this topic, I am locking topic to avoid confusion & mutiple posts relating to the same issue.
If you have any replies regarding Can component then can you please reply to the above link.
If you have any replies regarding Can component then can you please reply to the above link.
Martin