Hi Everybody,
Has anybody got a example of code for two micros sending data to each other over TCP/IP using ENC28J60. I have read the Embedded Internet Course Notes but nothing seems to match all the macros in the course to the componet so need some help on how to do this.
Thanks,
Wayne
TCP/IP Comms HELP
Moderator: Benj
-
- Posts: 234
- Joined: Thu May 31, 2007 2:18 pm
- Has thanked: 7 times
- Been thanked: 12 times
- Contact:
- LeighM
- Matrix Staff
- Posts: 2178
- Joined: Tue Jan 17, 2012 10:07 am
- Has thanked: 481 times
- Been thanked: 699 times
- Contact:
Re: TCP/IP Comms HELP
Hi Wayne,
The WIZ810 and W5500 based components work very well. These were used with the Embedded Internet Course.
The ENC28J60 is a much lower device and needs a lot of code to drive it.
A component was started for this device, based on some Arduino library, but it needs more work to be usable in all situations.
I think it is probably OK for responding to connections, but not initiating them, that's as I recall.
Maybe a search of posts on the forum might give more clues as to how others have used the device and component.
So in the short term at least I would suggest that you use a W5500 device such as the ETH WIZ click if that is possible.
The WIZ810 and W5500 based components work very well. These were used with the Embedded Internet Course.
The ENC28J60 is a much lower device and needs a lot of code to drive it.
A component was started for this device, based on some Arduino library, but it needs more work to be usable in all situations.
I think it is probably OK for responding to connections, but not initiating them, that's as I recall.
Maybe a search of posts on the forum might give more clues as to how others have used the device and component.
So in the short term at least I would suggest that you use a W5500 device such as the ETH WIZ click if that is possible.