Hi everybody,
Is their a problem with all the interrupts in the simulation for 18F4620. I have tried INT0 - INT2 and IOC and they all fire without being triggered.
I hope that there is a fix.
Thanks
Wayne Millard
INTERRUPT PROBLEM
Moderator: Benj
-
- Posts: 234
- Joined: Thu May 31, 2007 2:18 pm
- Has thanked: 7 times
- Been thanked: 12 times
- Contact:
-
- Matrix Staff
- Posts: 9520
- Joined: Sat May 05, 2007 2:27 pm
- Location: Northamptonshire, UK
- Has thanked: 2585 times
- Been thanked: 3815 times
- Contact:
Re: INTERRUPT PROBLEM
Hi Wayne,
If the interrupts are causing an issue during simulation, then you can use the Is Sim component.
I have attached an example.
Just keep pressing single step (F8) to start and run.
If the interrupts are causing an issue during simulation, then you can use the Is Sim component.
I have attached an example.
Just keep pressing single step (F8) to start and run.
- Attachments
-
- Is Sim Example.fcfx
- (13.64 KiB) Downloaded 152 times
Martin
-
- Posts: 234
- Joined: Thu May 31, 2007 2:18 pm
- Has thanked: 7 times
- Been thanked: 12 times
- Contact:
Re: INTERRUPT PROBLEM
Martin,
Thanks for a work around i would like to see the interrupts fixed and also been having problems with the generic LCD resizing, the only way is to resize project panel in flowcode 6 you could resize the LCD which was good. also the display does not work for more than 20 columns and the rows also problem. When I select the display size it is missing half the display and the only way to get it to work is to close program and then reopen or by resizing. I would like to see this fixed as well.
Thanks,
Wayne
Thanks for a work around i would like to see the interrupts fixed and also been having problems with the generic LCD resizing, the only way is to resize project panel in flowcode 6 you could resize the LCD which was good. also the display does not work for more than 20 columns and the rows also problem. When I select the display size it is missing half the display and the only way to get it to work is to close program and then reopen or by resizing. I would like to see this fixed as well.
Thanks,
Wayne