* EDIT See above posts!
Hey, Just got the PIC8 Pack and I am playing with the chip and it looks like there are some config bit missing from the configuration.
Thanks,
Chad
Add extra internal clock config stuff to PIC 12f1501 ( Use the Internal Ocillator Helper)
Moderator: Benj
- QMESAR
- Valued Contributor
- Posts: 1287
- Joined: Sun Oct 05, 2014 3:20 pm
- Location: Russia
- Has thanked: 384 times
- Been thanked: 614 times
- Contact:
Re: Add extra internal clock config stuff to PIC 12f1501
Hi.
Not sure what you are missing however the chip support 4 modes for Clock settings all 4 are available in FC
Not sure what you are missing however the chip support 4 modes for Clock settings all 4 are available in FC
https://www.flowcodexchange.com/
Regards QMESAR
Regards QMESAR
-
- Posts: 198
- Joined: Sun Nov 04, 2018 7:13 pm
- Has thanked: 27 times
- Been thanked: 33 times
- Contact:
Re: Add extra internal clock config stuff to PIC 12f1501 (found it)
Hey, I found that. What I couldn't find was the Internal Oscillator Helper. Got it all going.
I have another problem now but I will post that elese ware.
Thanks
Chad
I have another problem now but I will post that elese ware.
Thanks
Chad
- QMESAR
- Valued Contributor
- Posts: 1287
- Joined: Sun Oct 05, 2014 3:20 pm
- Location: Russia
- Has thanked: 384 times
- Been thanked: 614 times
- Contact:
Re: Add extra internal clock config stuff to PIC 12f1501
Hi
If you are looking to set the internal OSC at different speeds
(1) place a INTOSC helper on the 3D panel,then open properties set the clock speed you want (I used 16Mhz here)
You will see a value for the OSCCON register in the properties now place a C icon at the beginning of your Flowchart and enter this value in a call
as I show here and now compile your chart and the chip will run at your selected Internal OSC frequency
If you are looking to set the internal OSC at different speeds
(1) place a INTOSC helper on the 3D panel,then open properties set the clock speed you want (I used 16Mhz here)
You will see a value for the OSCCON register in the properties now place a C icon at the beginning of your Flowchart and enter this value in a call
as I show here and now compile your chart and the chip will run at your selected Internal OSC frequency
https://www.flowcodexchange.com/
Regards QMESAR
Regards QMESAR
- QMESAR
- Valued Contributor
- Posts: 1287
- Joined: Sun Oct 05, 2014 3:20 pm
- Location: Russia
- Has thanked: 384 times
- Been thanked: 614 times
- Contact:
Re: Add extra internal clock config stuff to PIC 12f1501
Glad you found it while I was making this post
https://www.flowcodexchange.com/
Regards QMESAR
Regards QMESAR
-
- Posts: 198
- Joined: Sun Nov 04, 2018 7:13 pm
- Has thanked: 27 times
- Been thanked: 33 times
- Contact:
Re: Add extra internal clock config stuff to PIC 12f1501
Thanks, I remembered seeing it a while back. It seems like that should be just built into the configurator?
I just posted a little pwm issue.. On to the next thing. . .
Yet another new chip;)
Chad
I just posted a little pwm issue.. On to the next thing. . .
Yet another new chip;)
Chad