Is the AVR Dragon Programmer Supported?

[ngmflowcode]

Is the AVR Dragon Programmer and ICD supported?

-NGM

[medelec35]

Please do not post multiple posts on the same topic.
I have deleted your other post asking the same question.

Thank you

[ngmflowcode]

I apologize, it was an issue with the refresh in my browser.

-NGM

[dazz]

Hi
It should work, im kinda busy so if you can find a list of command line parameters, and the command line programmer software and post a link i will see if i can figure it out for you, another option is to compile to hex in flowcode then program the hex using avr studio

Regards
Dazz

[ngmflowcode]

There are some examples on this page, not sure if it is enough.

http://support.atmel.com/bin/customer.e ... try&id=686

Despite being in the free forum, we now own a full AVR Flow Code 5 version license.

-NGM

[dazz]

Hi ngm
I will have a look when i've got a spare few minutes, can you sigh=n up to the V5 forum using the link in my sig

Regards
Dazz

[dazz]

Hi

I dont have a dragon but try the programmer setting in your config see image below, this assumes you have the avr dragon command line tool installed, you may have to change the location to suit your pc

Regards

Dazz

Try.jpg (62.47 KiB) Viewed 4454 times