Chip Configuration Settings

For Flowcode users to discuss projects, flowcharts, and any other issues related to Flowcode 5.
To post in this forum you must have a registered copy of Flowcode 5 or higher.

Moderator: Benj

Post Reply
Posts: 268
Joined: Tue Mar 05, 2013 10:49 pm
Has thanked: 111 times
Been thanked: 13 times

Chip Configuration Settings

Post by JDR04 »

OK, thanks to the help from the forum members my project is somewhat closer to completion. The C and Hex compiling all seems to be working fine.

However, when I try and burn to the chip,16F690 (using PICkit2 and Low Pin Count Board) it appears the program is not being loaded into the chip.

The PICkit2 programmer Power, Target lights are on and the Red busy light flickers as if it is programming the chip?

So I'm thinking I have configured the chip incorrectly. I have attached a screen grab for somebody to look at and kindly point out what I have set up wrongly.

Thanks again everybody................John
16f690-Chip Config.jpg
16f690-Chip Config.jpg (36.49 KiB) Viewed 2149 times
(17.5 KiB) Downloaded 136 times

User avatar
Posts: 263
Joined: Fri Dec 16, 2011 3:20 pm
Has thanked: 116 times
Been thanked: 113 times

Re: Chip Configuration Settings

Post by STibor »


Default internal 4MHz clock. (see datasheet FREQUENCY SELECT BITS (IRCF))
Configuration settings: internal clock, no clock output.
(13.5 KiB) Downloaded 157 times

Post Reply