Matrix has great E-blocks and it would be nice to use then with other development boards.
In my present project I am developing with a dsPIC33EP512MU810 and Matrix has no experimental board
for this 100 pin chip. It seems possible to program the Mikroe easyPIC-Fusion card from Flowcode
but I am missing an adapter that will allow the use of E-blocks.
The picture shows how I think that the connection must be done (no guarantee that this is correct)
As far as I can see, a flat cable mass termination will not work. This can only work if the SUB 9 connector
had its connections 0,1,2,3... in Zic-Zac
Is there already such an adapter available somewhere ?
Otherwise it is necessary to hand-solder something.
Looking forward to comments or solutions
Thanks and best regards
Bengt
Use E-blocks in other systems
-
- Posts: 111
- Joined: Wed Mar 02, 2016 11:26 am
- Has thanked: 43 times
- Been thanked: 22 times
- Contact:
Use E-blocks in other systems
- Attachments
-
- connect_mikroe_2_matrix.jpg
- (101.21 KiB) Downloaded 1449 times
- Steve
- Matrix Staff
- Posts: 3424
- Joined: Tue Jan 03, 2006 3:59 pm
- Has thanked: 114 times
- Been thanked: 422 times
- Contact:
Re: Use E-blocks in other systems
I don't believe an adaptor is available, so you will need to make one yourself.
- LeighM
- Matrix Staff
- Posts: 2178
- Joined: Tue Jan 17, 2012 10:07 am
- Has thanked: 481 times
- Been thanked: 699 times
- Contact:
Re: Use E-blocks in other systems
also you could try pre-made "jumper wires", search a hobby shop, between your dev board and the e-blocks "patch area" header pins or wire sockets