supported diveces EB006

For E-blocks user to discuss using E-blocks and programming for them.

Moderators: Benj, Mods

Post Reply
Werner LJ
Posts: 1
Joined: Sat Nov 25, 2017 2:53 pm
Contact:

supported diveces EB006

Post by Werner LJ »

Hi,
Is there a reason why program device EB006 supports far fewer devices than flow code? Will more devices be supported by program device EB006 in the near future?

kersing
Valued Contributor
Valued Contributor
Posts: 1939
Joined: Wed Aug 27, 2008 10:31 pm
Location: Netherlands
Contact:

Re: supported diveces EB006

Post by kersing »

The EB006 can only support devices where pins are at a defined position (power, OSC, reset and I/O ports). The software can support devices regardless where the pins are located on the physical package.
“Integrity is doing the right thing, even when no one is watching.”

― C.S. Lewis

User avatar
Steve001
Valued Contributor
Valued Contributor
Posts: 1145
Joined: Wed Dec 31, 2008 3:37 pm
Contact:

Re: supported diveces EB006

Post by Steve001 »

Hi Werner LJ

If you have a EB006 V9 programming Board

Then you can connect a pickit 3 via the adaptor lead that is available from microchip and program more devices via ICSP (after moving the links on the board)

I am not sure if the "GHOST" feature works on devices that are not on the device list - matrix will be able to confirm this.

https://www.microchipdirect.com/product ... l/TPROG001

I am using this method with no problems experienced to date

Steve
Attachments
20171126_081215.jpg
20171126_081215.jpg (69.36 KiB) Viewed 2218 times
Success always occurs in private and failure in full view.

User avatar
Benj
Matrix Staff
Posts: 14851
Joined: Mon Oct 16, 2006 10:48 am
Location: Matrix TS Ltd
Contact:

Re: supported diveces EB006

Post by Benj »

Is there a reason why program device EB006 supports far fewer devices than flow code? Will more devices be supported by program device EB006 in the near future?
On the newer PIC devices the programming scheme changes completely. The EB006 firmware doesn't support the new programming scheme.
I am not sure if the "GHOST" feature works on devices that are not on the device list - matrix will be able to confirm this.
Yes Ghost will work fine. For ICD to work you need the programming jumper in the USB position.

Post Reply