After I prescribed Compare$()
Stopped working ToString$()
Remained workers only the text !
This is after update!!!
And all I had from this project to remove all the macros and put them zanovo
Because after the update the compiler simply did not see them!!!!
In General horror!!!
Converter is not working
Moderator: Benj
- LeighM
- Matrix Staff
- Posts: 2178
- Joined: Tue Jan 17, 2012 10:07 am
- Has thanked: 481 times
- Been thanked: 699 times
- Contact:
Re: Converter is not working
Hi,
I am not sure exactly what problem you are reporting.
But I did notice a couple of issues:
Text normally needs the background drawing too, so you need transparency turned off...
C code does not simulate, so the variable will not increment in the simulator unless you use a calculation icon...
Hope that resolves your problem, if not please could you give more details.
Leigh
I am not sure exactly what problem you are reporting.
But I did notice a couple of issues:
Text normally needs the background drawing too, so you need transparency turned off...
C code does not simulate, so the variable will not increment in the simulator unless you use a calculation icon...
Hope that resolves your problem, if not please could you give more details.
Leigh
Re: Converter is not working
I'm not using the simulator!
Can I use my code ?
I have an electronic Board with a processor.
Now nothing works !!!
SPI - not working !
display not working!
The display is not initialized
and no cleaning !
Previously cleaned!
Can I use my code ?
I have an electronic Board with a processor.
Now nothing works !!!
SPI - not working !
display not working!
The display is not initialized
and no cleaning !
Previously cleaned!
- LeighM
- Matrix Staff
- Posts: 2178
- Joined: Tue Jan 17, 2012 10:07 am
- Has thanked: 481 times
- Been thanked: 699 times
- Contact:
Re: Converter is not working
Could you make the above changes, then "Compile to chip" and post your MD.msg.txt file?
Re: Converter is not working
It's my fault.....
I made a delay at the beginning of the code and everything began to work!!!
Probably a programming problem...
My apologies!!!!
I'm confused with the Compare$ function
With respect Osta
I made a delay at the beginning of the code and everything began to work!!!
Probably a programming problem...
My apologies!!!!
I'm confused with the Compare$ function
With respect Osta
- LeighM
- Matrix Staff
- Posts: 2178
- Joined: Tue Jan 17, 2012 10:07 am
- Has thanked: 481 times
- Been thanked: 699 times
- Contact:
Re: Converter is not working
OK, glad it's now working.
The Compare$ function returns 0 if the strings are the same.
The Compare$ function returns 0 if the strings are the same.