Could you help me with -
The data manual for the pic18f2553 indicates that RA6 is I/O for general purpose I/O. When I try to output to that pin, only 0 through 5 are in the selection. I'm using internal oscillators, and tried multiple selections (I think there are only 4).
Can you direct me? Is this a configuration issue or has FC7 got an issue?
PIC18f2553 RA6
Moderator: Benj
-
- Matrix Staff
- Posts: 9520
- Joined: Sat May 05, 2007 2:27 pm
- Location: Northamptonshire, UK
- Has thanked: 2585 times
- Been thanked: 3815 times
- Contact:
Re: PIC18f2553 RA6
Hi, as an unofficial fix, can you try with the attached file.
Drop into your Flowcode7 installation \FCD\PIC directory then reload flowchart.
Drop into your Flowcode7 installation \FCD\PIC directory then reload flowchart.
- Attachments
-
- 18F2553.fcdx
- (27.48 KiB) Downloaded 221 times
Martin
-
- Posts: 67
- Joined: Tue Sep 16, 2008 2:09 pm
- Location: Minnesota USA
- Has thanked: 4 times
- Been thanked: 17 times
- Contact:
Re: PIC18f2553 RA6
I will look into doing that over the weekend, can I instead change the icon code to reflect the port number?
-
- Posts: 67
- Joined: Tue Sep 16, 2008 2:09 pm
- Location: Minnesota USA
- Has thanked: 4 times
- Been thanked: 17 times
- Contact:
Re: PIC18f2553 RA6
I renamed the old file, and copied your file into the directory. Relaunched FC7 and now I get to select A6 as an output.
Thanks for this.
Thanks for this.
-
- Matrix Staff
- Posts: 9520
- Joined: Sat May 05, 2007 2:27 pm
- Location: Northamptonshire, UK
- Has thanked: 2585 times
- Been thanked: 3815 times
- Contact:
Re: PIC18f2553 RA6
You're welcome.
Hope it works on hardware for you.
Thank for letting us know.
Hope it works on hardware for you.
Thank for letting us know.
Martin