Hi Team,
I was wondering if it is possible to create a display component for the FT813, 800x480px. It also uses the riverdi click to interface with mikroe board. I attached some pics. If it is can somebody help with this
Thanks I appreciate
Rod
Component for display FT813
Moderator: Benj
-
- Posts: 198
- Joined: Sun Nov 04, 2018 7:13 pm
- Has thanked: 27 times
- Been thanked: 33 times
- Contact:
Re: Component for display FT813
That is a very cool setup. It looks pretty easy to deal with. The problem is it does SO MUCH STUFF it would be weeks worth of programing to build a component. I am guessing it isn't cheap either (~$70 for the display+$90 for the screen layout software).
Very cool though.
chad
Very cool though.
chad
-
- Matrix Staff
- Posts: 9520
- Joined: Sat May 05, 2007 2:27 pm
- Location: Northamptonshire, UK
- Has thanked: 2585 times
- Been thanked: 3815 times
- Contact:
Re: Component for display FT813
The Screen layout software is free and is called ESD from FTDI websitechad wrote:$90 for the screen layout software
I think the general idea is to use the circuit posted on the website and make you own hardware.
Then the touch screen is fairly cheap as you use a standard 40pin RGB with restive or capacitive touch.
The good thing about the FT81x range is it supports image tagging.
That means you assign each shape or image to a tag.
Then keep reading the tag register.
As soon as image is press then the register will be loaded with the correct tag.
No if x > 25 and < 45 etc.
Martin
-
- Posts: 198
- Joined: Sun Nov 04, 2018 7:13 pm
- Has thanked: 27 times
- Been thanked: 33 times
- Contact:
Re: Component for display FT813
You are correct!. I was looking at the mikro screen software. My bad... regardless, neat display chip!
chad
chad