Hello Community
I want to embed the PICKIT 3 in my flow code. I have tried this according to the instructions "PICkit3 - IPE (NEW)".
From my point of view everything works until the moment the mLoader is loaded. Then I get the error message "No device detected". What else do I have to set to load the program into the PIC?
Integrate PICKIT into flowcode
Moderator: Benj
-
- Posts: 89
- Joined: Wed Aug 31, 2016 4:48 pm
- Been thanked: 4 times
- Contact:
Integrate PICKIT into flowcode
- Attachments
-
- 2019-10-23 21_55_43-Window.png
- (3.18 KiB) Downloaded 587 times
-
- 2019-10-23 21_50_19-Window.png
- (25.54 KiB) Downloaded 587 times
-
- Matrix Staff
- Posts: 9520
- Joined: Sat May 05, 2007 2:27 pm
- Location: Northamptonshire, UK
- Has thanked: 2585 times
- Been thanked: 3815 times
- Contact:
Re: Integrate PICKIT into flowcode
Flowcode will compile and program using whatever Compiler optionis ticked (which is shown as a bold font).
In your case the Default is selected, hence using mLoader as the programmer and not PICkit3.
Martin
-
- Posts: 89
- Joined: Wed Aug 31, 2016 4:48 pm
- Been thanked: 4 times
- Contact: