FC8 7Segment (Quad) simulation error

For questions and comments on programming in general. And for any items that don't fit into the forums below.

Moderators: Benj, Mods

Post Reply
Posts: 11
Joined: Sun Jun 10, 2018 1:24 pm

FC8 7Segment (Quad) simulation error

Post by Lariekoek »

Using FC8, the simulation of the "7Segment (Quad)" component is not working when using normal output icons (so not using the component macro).
To simulate it, I have to use 4 "7Segment (Single) displays. Is this an error in the Quad component?

See code in attachment (the 7Seg-displays are common anode).

Thanks in advance!
(24.65 KiB) Downloaded 61 times

Post Reply