Afternoon All,
Been a while since i last had a go - bit rusty and forgot .... if someone can help me out
Need a bit of guidance want to have
internal oscillator - 16 mhz
i have my Eblock Board (V9) set ICSP (pickit3
J19 set to A6 & 7
not managed to get any where with it ..
PIC16F1828
https://uk.rs-online.com/web/p/microcon ... s/7154393/
Steve
Project Settings
Moderator: Benj
- Steve001
- Valued Contributor
- Posts: 1189
- Joined: Wed Dec 31, 2008 3:37 pm
- Has thanked: 460 times
- Been thanked: 523 times
- Contact:
Project Settings
- Attachments
-
- test 1.fcfx
- (12.33 KiB) Downloaded 208 times
Success always occurs in private and failure in full view.
- QMESAR
- Valued Contributor
- Posts: 1287
- Joined: Sun Oct 05, 2014 3:20 pm
- Location: Russia
- Has thanked: 384 times
- Been thanked: 614 times
- Contact:
Re: Project Settings
Steve
Try this I do not have the device to check but this settings should be good for 16MHZ Internal
Try this I do not have the device to check but this settings should be good for 16MHZ Internal
https://www.flowcodexchange.com/
Regards QMESAR
Regards QMESAR
- Steve001
- Valued Contributor
- Posts: 1189
- Joined: Wed Dec 31, 2008 3:37 pm
- Has thanked: 460 times
- Been thanked: 523 times
- Contact:
Re: Project Settings
Hi Peter
Thank you for that, will have a go later when charlie goes shopping
Steve
Thank you for that, will have a go later when charlie goes shopping
Steve
Success always occurs in private and failure in full view.
- Steve001
- Valued Contributor
- Posts: 1189
- Joined: Wed Dec 31, 2008 3:37 pm
- Has thanked: 460 times
- Been thanked: 523 times
- Contact:
Re: Project Settings
Hi Peter
working thank you
Steve
working thank you
Steve
Success always occurs in private and failure in full view.