RS232 simulation component
In the project, I have two (RS232 ports).
RS232 (0) is used.
RS232 (1) is not being used.
In the panel I have the (UART1 and UART2) replaced more often.
When I turn on the simulation, always RS232 (0) disappears.
No matter if selected (UART1 or UART2)
After the simulation, RS232 (0) will return.
The transmitted data can be seen in the window.
Sincerely
Uwe
Simulation (RS232 component)
Moderator: Benj
-
- Posts: 33
- Joined: Tue May 08, 2012 3:48 pm
- Location: Germany
- Has thanked: 7 times
- Contact:
- Benj
- Matrix Staff
- Posts: 15312
- Joined: Mon Oct 16, 2006 10:48 am
- Location: Matrix TS Ltd
- Has thanked: 4803 times
- Been thanked: 4314 times
- Contact:
Re: Simulation (RS232 component)
Hello Uwe,
In the EXT properties for the RS232(0) there is a setting called show simulation. Please ensure that this is ticked and the RS232 window should then remain on the panel for simulation.
In the EXT properties for the RS232(0) there is a setting called show simulation. Please ensure that this is ticked and the RS232 window should then remain on the panel for simulation.
Regards Ben Rowland - MatrixTSL
Flowcode Product Page - Flowcode Help Wiki - Flowcode Examples - Flowcode Blog - Flowcode Course - My YouTube Channel
Flowcode Product Page - Flowcode Help Wiki - Flowcode Examples - Flowcode Blog - Flowcode Course - My YouTube Channel
-
- Posts: 33
- Joined: Tue May 08, 2012 3:48 pm
- Location: Germany
- Has thanked: 7 times
- Contact: