Chip Configuration Settings

For Flowcode users to discuss projects, flowcharts, and any other issues related to Flowcode 5.
To post in this forum you must have a registered copy of Flowcode 5 or higher.

Moderator: Benj

Posts: 264
Joined: Tue Mar 05, 2013 10:49 pm
Has thanked: 111 times
Been thanked: 13 times

Chip Configuration Settings

Postby JDR04 » Sat May 17, 2014 11:45 pm

OK, thanks to the help from the forum members my project is somewhat closer to completion. The C and Hex compiling all seems to be working fine.

However, when I try and burn to the chip,16F690 (using PICkit2 and Low Pin Count Board) it appears the program is not being loaded into the chip.

The PICkit2 programmer Power, Target lights are on and the Red busy light flickers as if it is programming the chip?

So I'm thinking I have configured the chip incorrectly. I have attached a screen grab for somebody to look at and kindly point out what I have set up wrongly.

Thanks again everybody................John
16f690-Chip Config.jpg
16f690-Chip Config.jpg (36.49 KiB) Viewed 1851 times
(17.5 KiB) Downloaded 100 times

User avatar
Posts: 262
Joined: Fri Dec 16, 2011 3:20 pm
Has thanked: 115 times
Been thanked: 112 times

Re: Chip Configuration Settings

Postby STibor » Sun May 18, 2014 6:40 am


Default internal 4MHz clock. (see datasheet FREQUENCY SELECT BITS (IRCF))
Configuration settings: internal clock, no clock output.
(13.5 KiB) Downloaded 121 times
These users thanked the author STibor for the post (total 2):
medelec35 (Sun May 18, 2014 9:29 am) • JDR04 (Tue May 20, 2014 2:42 pm)
Rating: 10%