Hi!
Ive got a setup of 2 eb006 and one miac unit. For some reason today the mLoader asks to reset device before programming this specific eb006 (Eb006 i want to program is only device connected).
Now when i plug it in, windows says "last device attached is broken", and try to program, and press reset when mLoader asks, the bluescreen appears with "System thread expection not handled (mchpusb64.sys)".
This unit is pretty new (from last summer), so any ideas how to restore the on-board PIC 18F4455 to function normally?
These units have always been programmed with usb, have not used PICkit or similar for them.
Other unit works fine, and has no problems. Tried re-installing drivers.
EDIT: Was fast enough to take a picture of the bluescreen:
https://www.dropbox.com/s/qusj72cmpntui ... 9.jpg?dl=0
[SOLVED, kinda] Flowcode v6 and eb006 causes bluescreen.
Moderator: Benj
-
- Posts: 444
- Joined: Tue Apr 15, 2014 4:19 pm
- Location: Kajaani, Finland
- Has thanked: 345 times
- Been thanked: 227 times
- Contact:
[SOLVED, kinda] Flowcode v6 and eb006 causes bluescreen.
Last edited by EtsDriver on Wed May 06, 2015 4:34 pm, edited 1 time in total.
Ill just keep the good work up!
- DavidA
- Matrix Staff
- Posts: 1076
- Joined: Fri Apr 23, 2010 2:18 pm
- Location: Matrix Multimedia Ltd
- Has thanked: 58 times
- Been thanked: 258 times
- Contact:
Re: Flowcode v6 and eb006 causes bluescreen.
Hello,
Do you have multiple devices from Matrix plugged in at the same time? If so can you try with only one device plugged in at a time.
Do you have multiple devices from Matrix plugged in at the same time? If so can you try with only one device plugged in at a time.
-
- Posts: 444
- Joined: Tue Apr 15, 2014 4:19 pm
- Location: Kajaani, Finland
- Has thanked: 345 times
- Been thanked: 227 times
- Contact:
Re: Flowcode v6 and eb006 causes bluescreen.
As written, only one at time. But decided to dump that oddly acting multiprogrammer, gonna get new eb006-00-9, case closed!
Ill just keep the good work up!