Using Clock out Pin

For Flowcode users to discuss projects, flowcharts, and any other issues related to Flowcode 8.

Moderator: Benj

Post Reply
CSM2711
Posts: 47
Joined: Mon Apr 16, 2018 10:28 am
Location: Germany
Has thanked: 1 time
Been thanked: 9 times
Contact:
Contact CSM2711

Using Clock out Pin

Post by CSM2711 »

Hello,

I want to check the configuration of my PIC16F18313, for this i want to measure the System cloch by using the clock out Pin.
I configure the device as in the attached picture but there is no output on PIN3.
Can everybody tell me whats wrong ?
Attachments
clk_out.JPG
clk_out.JPG (95.28 KiB) Viewed 1513 times
Top
CSM2711
Posts: 47
Joined: Mon Apr 16, 2018 10:28 am
Location: Germany
Has thanked: 1 time
Been thanked: 9 times
Contact:
Contact CSM2711

Re: Using Clock out Pin

Post by CSM2711 »

ok, was my fault .......
I shorted the port pin in my electronics ........ :roll:
Top
Post Reply

Return to “Flowcode V8”