NOTE: When using PICKIT3 with Flowcode, please name your fcf files without spaces, underscores are allowed.
To allow PICkit 3 to work with Flowcode 5 you must first copy the contents of the archive below into your "Flowcode\v5\Tools" folder which is normally located at "C:\Program Files\".
http://www.matrixtsl.com/resourc ... php?id=603
Then in Flowcode click on Build >> Compiler options and navigate to the Programmer tab.
Set the Programmer location to:
Or on a 64-bit machine
Set the Programmer parameters to:
or for 16-bit PICs
This configures the PICkit 3 to program the target devices using the project hex file. The PICkit will erase the device, fully program the device and then verify the data has been programmed correctly onto the device.
To allow PPP to provide configuration settings simply leave the Use external program to set config options setting ticked and leave the details as.
Location
Parameters
Some users have reported problems when using the settings listed above. They get the error "hex file not found".
Changing the programmer parameters to this seems to fix this problem.
To allow PICkit 3 to work with Flowcode 5 you must first copy the contents of the archive below into your "Flowcode\v5\Tools" folder which is normally located at "C:\Program Files\".
http://www.matrixtsl.com/resourc ... php?id=603
Then in Flowcode click on Build >> Compiler options and navigate to the Programmer tab.
Set the Programmer location to:
C:\Program Files\Flowcode\V5\Tools\PICkit3\pk3cmd.exe
Or on a 64-bit machine
C:\Program Files (x86)\Flowcode\V5\Tools\PICkit3\pk3cmd.exe
Set the Programmer parameters to:
-P%p -F%f.hex -E -M
or for 16-bit PICs
-P%p -F%f.hex -E -M -L
This configures the PICkit 3 to program the target devices using the project hex file. The PICkit will erase the device, fully program the device and then verify the data has been programmed correctly onto the device.
To allow PPP to provide configuration settings simply leave the Use external program to set config options setting ticked and leave the details as.
Location
C:\Program Files\Flowcode\V5\Tools\PPP\PPPv3.exe
Parameters
-cs 2 -chip PIC%p -config
Some users have reported problems when using the settings listed above. They get the error "hex file not found".
Changing the programmer parameters to this seems to fix this problem.
-P%p -F"%f.hex" -E -M -L