Attached is a flowchart that stops running when single stepping at the same point.
In the screen shot below, if press F8 when reached this point, flowchart will stop.
If the timer interrupt is removed, then flowchart will continue to run indefinitely.
The 1 second delay has something to do with the bug since if removed, again flowchart will continue to run indefinitely.
Timer interrupt bug
Moderator: Benj
Forum rules
Only bug reports will be considered here. General questions should not be posted in this forum.
Only bug reports will be considered here. General questions should not be posted in this forum.
-
- Matrix Staff
- Posts: 9520
- Joined: Sat May 05, 2007 2:27 pm
- Location: Northamptonshire, UK
- Has thanked: 2585 times
- Been thanked: 3815 times
- Contact:
Re: Timer interrupt bug
I find a similar bug in the Frequency Counter demo program.
It runs but, no matter how fast the button is pressed, the readout on the display remains at 1Hz (with the odd flicker to 2Hz). I have a program written in Flowcode 5 which has a similar structure and works perfectly. When imported into Flowcode 6 it show the same behaviour as the Frequency Counter example.
It runs but, no matter how fast the button is pressed, the readout on the display remains at 1Hz (with the odd flicker to 2Hz). I have a program written in Flowcode 5 which has a similar structure and works perfectly. When imported into Flowcode 6 it show the same behaviour as the Frequency Counter example.