Hi,
There is a problem with the RFID BL0197 component. This component is not initialized.
The component was connected to the BL0011 Board to B and C ports.
I used the RFID (EB052, RWD MICODE) component in Flowcode 8.2 and tried to set up different ports (B and C) in the connection setup. I set the TX to pin 0, RX to 1 and CTS to 4 (as in E blocks 2 datasheet).
I also tried using RFID (MFRC522) component but it didn't work. Port connection settings are different from that in the datasheet., so I do not think that use this component is correct.
How to use these settings in the right way?
E-blocks 2 RFID Board (BL0197)
-
- Posts: 26
- Joined: Tue Sep 18, 2018 5:22 pm
- Has thanked: 1 time
- Been thanked: 3 times
- Contact:
- Benj
- Matrix Staff
- Posts: 15312
- Joined: Mon Oct 16, 2006 10:48 am
- Location: Matrix TS Ltd
- Has thanked: 4803 times
- Been thanked: 4314 times
- Contact:
Re: E-blocks 2 RFID Board (BL0197)
Hello,
Here is a program you can try.
Connect a combo board to Ports A and B or an BL0169 LCD to Port B and connect the RFID board to Port C only.
Here is a program you can try.
Connect a combo board to Ports A and B or an BL0169 LCD to Port B and connect the RFID board to Port C only.
Regards Ben Rowland - MatrixTSL
Flowcode Product Page - Flowcode Help Wiki - Flowcode Examples - Flowcode Blog - Flowcode Course - My YouTube Channel
Flowcode Product Page - Flowcode Help Wiki - Flowcode Examples - Flowcode Blog - Flowcode Course - My YouTube Channel
-
- Posts: 26
- Joined: Tue Sep 18, 2018 5:22 pm
- Has thanked: 1 time
- Been thanked: 3 times
- Contact:
Re: E-blocks 2 RFID Board (BL0197)
Thanks, it really works.
I think the problem was that I set TX to 0 and RX to 1, but I had to do the opposite (TX to 1 and RX to 0).
I think the problem was that I set TX to 0 and RX to 1, but I had to do the opposite (TX to 1 and RX to 0).