hi,
Where can i find examples on how to use the sensor board? I have the wireless heart rate monitor and need to display its output on an LCD.
Which macros do I need to load to use the sensor board? Are there any instructions/examples for using the heart rate monitor? I can find very little information regarding this.
Thank you.
The sensor board and wireless heart rate monitor.
- Benj
- Matrix Staff
- Posts: 15312
- Joined: Mon Oct 16, 2006 10:48 am
- Location: Matrix TS Ltd
- Has thanked: 4803 times
- Been thanked: 4314 times
- Contact:
Re: The sensor board and wireless heart rate monitor.
Hello
Here is the datasheet for the heart rate monitor.
http://www2.vernier.com/booklets/ehr-bta.pdf
Also here is the datasheet for the analogue board.
http://www.matrixmultimedia.com/datashe ... 3-30-2.pdf
I would look at my frequency counter application available from the flowcode examples section for a guide on programming the application.
Here is the datasheet for the heart rate monitor.
http://www2.vernier.com/booklets/ehr-bta.pdf
Also here is the datasheet for the analogue board.
http://www.matrixmultimedia.com/datashe ... 3-30-2.pdf
I would look at my frequency counter application available from the flowcode examples section for a guide on programming the application.
Regards Ben Rowland - MatrixTSL
Flowcode Product Page - Flowcode Help Wiki - Flowcode Examples - Flowcode Blog - Flowcode Course - My YouTube Channel
Flowcode Product Page - Flowcode Help Wiki - Flowcode Examples - Flowcode Blog - Flowcode Course - My YouTube Channel
Re: The sensor board and wireless heart rate monitor.
um, where is the examples section? in the website orr this forum?
- Benj
- Matrix Staff
- Posts: 15312
- Joined: Mon Oct 16, 2006 10:48 am
- Location: Matrix TS Ltd
- Has thanked: 4803 times
- Been thanked: 4314 times
- Contact: