I get the following write error when I complie to the chip on the flowcode buggy.
Error: 31USB Write Failed
Failed with error 31: A device attached to the system is not functioning.
However the program down loads and in most cases the program will ru. Howeever it does not always work.
Any Ideas wht the problem may be?
Bill
write error but still works most of the time
- Benj
- Matrix Staff
- Posts: 15312
- Joined: Mon Oct 16, 2006 10:48 am
- Location: Matrix TS Ltd
- Has thanked: 4803 times
- Been thanked: 4314 times
- Contact:
Re: write error but still works most of the time
Hello Bill
Yes you are correct, the error is reported but the program is going into the buggy ok. You can download the latest version of the buggy software from here. This version does not have the programming error problem.
http://www.matrixmultimedia.com/softwar ... rammer.zip
Yes you are correct, the error is reported but the program is going into the buggy ok. You can download the latest version of the buggy software from here. This version does not have the programming error problem.
http://www.matrixmultimedia.com/softwar ... rammer.zip
Regards Ben Rowland - MatrixTSL
Flowcode Product Page - Flowcode Help Wiki - Flowcode Examples - Flowcode Blog - Flowcode Course - My YouTube Channel
Flowcode Product Page - Flowcode Help Wiki - Flowcode Examples - Flowcode Blog - Flowcode Course - My YouTube Channel