Dear all
I have a problem with my new Zigbee router/End point E-Block where its red led does not flash but it still light and the connection failed between coordinator and router
I will be pleasure to help me
thanks
Zigbee router/End point E-Block
Moderator: Benj
- Benj
- Matrix Staff
- Posts: 15312
- Joined: Mon Oct 16, 2006 10:48 am
- Location: Matrix TS Ltd
- Has thanked: 4803 times
- Been thanked: 4314 times
- Contact:
Re: Zigbee router/End point E-Block
Hello,
For both programs you need to ensure that the scan channel properties are set to the same set of channels, picking a single channel for both zigbee components can sometimes give better performance as the channel scan can sometimes get it wrong or pick a noisy channel.
Also check that you are calling the ConnectTo macros after the Initialise macro, Connect to all should allow you to send data around to everything.
For both programs you need to ensure that the scan channel properties are set to the same set of channels, picking a single channel for both zigbee components can sometimes give better performance as the channel scan can sometimes get it wrong or pick a noisy channel.
Also check that you are calling the ConnectTo macros after the Initialise macro, Connect to all should allow you to send data around to everything.
Regards Ben Rowland - MatrixTSL
Flowcode Product Page - Flowcode Help Wiki - Flowcode Examples - Flowcode Blog - Flowcode Course - My YouTube Channel
Flowcode Product Page - Flowcode Help Wiki - Flowcode Examples - Flowcode Blog - Flowcode Course - My YouTube Channel