This has maybe been asked before, but is it possible to use both CANBUS modules on a 30F6012A chip? I can successfully use 1 but if I add another CAN component to Flowcode i can't compile to HEX. Is it possible to map each CAN component to a specific CAN module on the chip?
Thanks
Using two CAN connections on 30F6012A
Moderator: Benj
- Benj
- Matrix Staff
- Posts: 15312
- Joined: Mon Oct 16, 2006 10:48 am
- Location: Matrix TS Ltd
- Has thanked: 4803 times
- Been thanked: 4314 times
- Contact:
Re: Using two CAN connections on 30F6012A
Hello,
Yes this might be possible, I have added two CAN components to the attached program below and used the code customisation to reroute the CAN1 component to internal CAN channel 2.
It compiles but there may be more issues lurking.
Flowcode v6 should support multiple internal CAN components out the box on this device so this could be an option if you run into problems.
Let me know how you get on.
Yes this might be possible, I have added two CAN components to the attached program below and used the code customisation to reroute the CAN1 component to internal CAN channel 2.
It compiles but there may be more issues lurking.
Flowcode v6 should support multiple internal CAN components out the box on this device so this could be an option if you run into problems.
Let me know how you get on.
Regards Ben Rowland - MatrixTSL
Flowcode Product Page - Flowcode Help Wiki - Flowcode Examples - Flowcode Blog - Flowcode Course - My YouTube Channel
Flowcode Product Page - Flowcode Help Wiki - Flowcode Examples - Flowcode Blog - Flowcode Course - My YouTube Channel