Would it be possible to right click on a variable that has been added to Simulation Debugger and select Break on change or Break when equal to.
Increased simulation speed is great!
But i feel some times that when debugging it would be handy to slow it down a bit (but higher than 50Hz).
when adding variables to Simulation Debugger for watching 50 can be a bit too slow and normal does not allow to view values.
perhaps the scale could be moved so perhaps 1Hz is the slowest and have a few values between 50Hz and normal?
Martin
Break on Variable change & Simulation speed.
Moderator: Benj
Forum rules
Only feature requests will be considered here. General questions should not be posted in this forum.
Only feature requests will be considered here. General questions should not be posted in this forum.
-
- Matrix Staff
- Posts: 9520
- Joined: Sat May 05, 2007 2:27 pm
- Location: Northamptonshire, UK
- Has thanked: 2585 times
- Been thanked: 3815 times
- Contact:
- Benj
- Matrix Staff
- Posts: 15312
- Joined: Mon Oct 16, 2006 10:48 am
- Location: Matrix TS Ltd
- Has thanked: 4803 times
- Been thanked: 4314 times
- Contact:
Re: Break on Variable change & Simulation speed.
Cheers Martin,
Yes I'll get this on the list, might be some issues with Windows timing but we can certainly have a look.
Yes I'll get this on the list, might be some issues with Windows timing but we can certainly have a look.
Regards Ben Rowland - MatrixTSL
Flowcode Product Page - Flowcode Help Wiki - Flowcode Examples - Flowcode Blog - Flowcode Course - My YouTube Channel
Flowcode Product Page - Flowcode Help Wiki - Flowcode Examples - Flowcode Blog - Flowcode Course - My YouTube Channel