Hi Team
using Ghost and dsPic30F when pressing the Ghost Run button Flowcode crash don`'t know may be it is the same issue as with PIC32 that Ben mentioned regarding the
.cof file .
hope these issue will be solved soon
FlowCode Crash when using Flowkit V2 with dsPIC30F
Moderator: Benj
- Benj
- Matrix Staff
- Posts: 15312
- Joined: Mon Oct 16, 2006 10:48 am
- Location: Matrix TS Ltd
- Has thanked: 4803 times
- Been thanked: 4314 times
- Contact:
Re: FlowCode Crash when using Flowkit V2 with dsPIC30F
Hello,
I think this problem may already be fixed. Please can you extract the attached files to your "Flowcode 7\compilers\pic16\batchfiles" directory.
Hopefully then the crash should be resolved, at least on 16-bit PIC devices.
I think this problem may already be fixed. Please can you extract the attached files to your "Flowcode 7\compilers\pic16\batchfiles" directory.
Hopefully then the crash should be resolved, at least on 16-bit PIC devices.
Regards Ben Rowland - MatrixTSL
Flowcode Product Page - Flowcode Help Wiki - Flowcode Examples - Flowcode Blog - Flowcode Course - My YouTube Channel
Flowcode Product Page - Flowcode Help Wiki - Flowcode Examples - Flowcode Blog - Flowcode Course - My YouTube Channel
- QMESAR
- Valued Contributor
- Posts: 1287
- Joined: Sun Oct 05, 2014 3:20 pm
- Location: Russia
- Has thanked: 384 times
- Been thanked: 614 times
- Contact:
Re: FlowCode Crash when using Flowkit V2 with dsPIC30F
Hi Ben
Thank you very much that has solved the crash issue
Just to inform you the Pins that is shown for the ICD incorrect it should be RF2 and RF3 for PGC and PGD
Thank you very much that has solved the crash issue
Just to inform you the Pins that is shown for the ICD incorrect it should be RF2 and RF3 for PGC and PGD
- Attachments
-
- 1.JPG (27.77 KiB) Viewed 2611 times
https://www.flowcodexchange.com/
Regards QMESAR
Regards QMESAR