Mloader problem
Arm chip on the EB-031 board
everything works as needed with the FC7 flach.
The same HEX file with only Mloader does not start the ARM chip
after execute.
the EB-031 is visible in the Mloader window.
select AT91SAM7S128
can you help me?
Mloader problems
Moderator: Benj
- Benj
- Matrix Staff
- Posts: 15312
- Joined: Mon Oct 16, 2006 10:48 am
- Location: Matrix TS Ltd
- Has thanked: 4803 times
- Been thanked: 4314 times
- Contact:
Re: Mloader problems
Have you tried clicking the Execute button in mLoader. Otherwise it will hold the board in programming mode.
Closing mLoader should have the same effect.
For the Atmel Arm devices you need to program the .s19 file rather than the .hex file.
Closing mLoader should have the same effect.
For the Atmel Arm devices you need to program the .s19 file rather than the .hex file.
Regards Ben Rowland - MatrixTSL
Flowcode Product Page - Flowcode Help Wiki - Flowcode Examples - Flowcode Blog - Flowcode Course - My YouTube Channel
Flowcode Product Page - Flowcode Help Wiki - Flowcode Examples - Flowcode Blog - Flowcode Course - My YouTube Channel