IO pin state when programming?

For questions and comments on programming in general. And for any items that don't fit into the forums below.

Moderators: Benj, Mods

Post Reply
jcooper
Posts: 23
Joined: Tue Jul 08, 2008 7:29 pm
Contact:
Contact jcooper

IO pin state when programming?

Post by jcooper »

Hey, I was just wondering what the state of the I/O pins is when programming through the PPP firmware. Are they driven high/low or high-impedance?
No trees were harmed in the posting of this message. However, a large number of electrons were terribly inconvenienced.
Top
User avatar
Benj
Matrix Staff
Posts: 15312
Joined: Mon Oct 16, 2006 10:48 am
Location: Matrix TS Ltd
Has thanked: 4803 times
Been thanked: 4314 times
Contact:
Contact Benj

Re: IO pin state when programming?

Post by Benj »

Hello

I/O pins should be driven to the high impedance state during reset and programming.
Top
Post Reply

Return to “General Programming”