I have tried two random 16 bit devices:
PIC24EP256MC202
&
PIC24EP256GP202
Both have UART RX shown as Unconnected with both Channel 1 and Channel 2, so will not compile.
UART 16Bit Devices
Moderator: Benj
-
medelec35
- Matrix Staff
- Posts: 9520
- Joined: Sat May 05, 2007 2:27 pm
- Location: Northamptonshire, UK
- Has thanked: 2585 times
- Been thanked: 3815 times
- Contact:
-
Benj
- Matrix Staff
- Posts: 15312
- Joined: Mon Oct 16, 2006 10:48 am
- Location: Matrix TS Ltd
- Has thanked: 4803 times
- Been thanked: 4314 times
- Contact:
Re: UART 16Bit Devices
Hi Martin,
I beleive these devices have remap pin properties available for you to specify the RX and TX pins? Though I could be wrong
I beleive these devices have remap pin properties available for you to specify the RX and TX pins? Though I could be wrong
Regards Ben Rowland - MatrixTSL
Flowcode Product Page - Flowcode Help Wiki - Flowcode Examples - Flowcode Blog - Flowcode Course - My YouTube Channel
Flowcode Product Page - Flowcode Help Wiki - Flowcode Examples - Flowcode Blog - Flowcode Course - My YouTube Channel
-
medelec35
- Matrix Staff
- Posts: 9520
- Joined: Sat May 05, 2007 2:27 pm
- Location: Northamptonshire, UK
- Has thanked: 2585 times
- Been thanked: 3815 times
- Contact:
Re: UART 16Bit Devices
Hi Ben,
Yes they do but there appears to be a bug with the remapping side which is causing the confusion: Unable to select a mapping pin (And is black to start with) until you select map Pin then it shows blank white box, then if click anywhere else within properties a remap pin appears.
Then you have to select the remapping pin.
The easiest way to see the bug as it does not always happen is select software choose unconnected, then select a channel.
I have just discovered that after posting so did not believe I could even select a pin until now.
Yes they do but there appears to be a bug with the remapping side which is causing the confusion: Unable to select a mapping pin (And is black to start with) until you select map Pin then it shows blank white box, then if click anywhere else within properties a remap pin appears.
Then you have to select the remapping pin.
The easiest way to see the bug as it does not always happen is select software choose unconnected, then select a channel.
I have just discovered that after posting so did not believe I could even select a pin until now.
Martin