Sorry!!!
Made a mistake with the settings !
It's working!!!!
ILI9341 SPI It's not working
Moderator: Benj
ILI9341 SPI It's not working
- Attachments
-
- JPG
- ILI9341ISP.jpg (123.48 KiB) Viewed 2232 times
-
- ILI9341_SPI.fcfx
- Proj
- (9.23 KiB) Downloaded 191 times
Re: ILI9341 SPI It's not working
By default, the display clears to 320x240.
A default graphics 240x320.
It's confusing.
A default graphics 240x320.
It's confusing.
- Attachments
-
- SET.jpg (79.04 KiB) Viewed 2227 times
- Benj
- Matrix Staff
- Posts: 15312
- Joined: Mon Oct 16, 2006 10:48 am
- Location: Matrix TS Ltd
- Has thanked: 4803 times
- Been thanked: 4314 times
- Contact:
Re: ILI9341 SPI It's not working
Hi Osta,
Glad it's working now
Change the screen dimension properties so that the entire display is cleared correctly on initialise, the width and height might need to be swapped. Then use the SetOrientation component macro to rotate the display to be the orientation you need.
Use the Position tab of the properties window to rotate the component on the Z axis to allow the sim to match the hardware.
Hope this helps.
Glad it's working now
Change the screen dimension properties so that the entire display is cleared correctly on initialise, the width and height might need to be swapped. Then use the SetOrientation component macro to rotate the display to be the orientation you need.
Use the Position tab of the properties window to rotate the component on the Z axis to allow the sim to match the hardware.
Hope this helps.
Regards Ben Rowland - MatrixTSL
Flowcode Product Page - Flowcode Help Wiki - Flowcode Examples - Flowcode Blog - Flowcode Course - My YouTube Channel
Flowcode Product Page - Flowcode Help Wiki - Flowcode Examples - Flowcode Blog - Flowcode Course - My YouTube Channel