Hi,
We just started working with E-blocks, and flowcode 4.
For some reason, we cannot get any input working, Both switches ( EB0070 001 and EB0074 ) on all possible input ports don't work.
Any Ideas what we are doing wrong ?
We have the 16F877A microcontroller.
Are there demo programs available somewhere ?
Regards
eblock inputs : not working
- Benj
- Matrix Staff
- Posts: 15312
- Joined: Mon Oct 16, 2006 10:48 am
- Location: Matrix TS Ltd
- Has thanked: 4803 times
- Been thanked: 4314 times
- Contact:
Re: eblock inputs : not working
Hello,
This should be straightforward enough to do. Are you wiring a connection from the +V terminal on the Multiprogrammer to the +V terminal on the switch E-block?
This should be straightforward enough to do. Are you wiring a connection from the +V terminal on the Multiprogrammer to the +V terminal on the switch E-block?
Regards Ben Rowland - MatrixTSL
Flowcode Product Page - Flowcode Help Wiki - Flowcode Examples - Flowcode Blog - Flowcode Course - My YouTube Channel
Flowcode Product Page - Flowcode Help Wiki - Flowcode Examples - Flowcode Blog - Flowcode Course - My YouTube Channel
-
- Matrix Staff
- Posts: 9520
- Joined: Sat May 05, 2007 2:27 pm
- Location: Northamptonshire, UK
- Has thanked: 2585 times
- Been thanked: 3815 times
- Contact:
Re: eblock inputs : not working
Have you done the 1 second led flash test?
You many not have set configuration settings up properly e.g watchdog timer and low voltage programming disabled etc.
Take a look at this post.
Martin
You many not have set configuration settings up properly e.g watchdog timer and low voltage programming disabled etc.
Take a look at this post.
Martin
Martin