When incorporating timer 4 into a program compiling fails with the errors listed below.
Unrelated to the above problem, when compiling the following message is given. This however does not seem to cause any problems with the operation of the program. I'm not sure if its anything that needs looking at? Thanks.
PIC18F26K80 errors on compiling when using timer 4
Moderator: Benj
- Benj
- Matrix Staff
- Posts: 15312
- Joined: Mon Oct 16, 2006 10:48 am
- Location: Matrix TS Ltd
- Has thanked: 4803 times
- Been thanked: 4314 times
- Contact:
Re: PIC18F26K80 errors on compiling when using timer 4
Hi Zane,
Thanks for letting us know of the problem.
I have now fixed the Timer 4 and config problems mentioned. Simply extract the attached file into your "Flowcode 7/FCD/PIC" folder and restart Flowcode to load the changes.
Thanks for letting us know of the problem.
I have now fixed the Timer 4 and config problems mentioned. Simply extract the attached file into your "Flowcode 7/FCD/PIC" folder and restart Flowcode to load the changes.
Regards Ben Rowland - MatrixTSL
Flowcode Product Page - Flowcode Help Wiki - Flowcode Examples - Flowcode Blog - Flowcode Course - My YouTube Channel
Flowcode Product Page - Flowcode Help Wiki - Flowcode Examples - Flowcode Blog - Flowcode Course - My YouTube Channel
-
- Flowcode v5 User
- Posts: 199
- Joined: Thu Sep 10, 2009 10:57 pm
- Location: New Zealand
- Has thanked: 93 times
- Been thanked: 76 times
- Contact:
Re: PIC18F26K80 errors on compiling when using timer 4
Hi Benj,
Thanks for the fix for this. I have tried this using hardware and it works a treat.
Thanks
Zane
Thanks for the fix for this. I have tried this using hardware and it works a treat.
Thanks
Zane