EDIT THE COMPONENT KEYPAD
Moderator: Benj
-
- Posts: 150
- Joined: Mon Oct 15, 2012 5:19 pm
- Has thanked: 12 times
- Been thanked: 18 times
- Contact:
EDIT THE COMPONENT KEYPAD
Hello all welcome .I would like to know if i edit the component Keypad to change the logic of the PullDown for Pullup.If it is not possible to make directly in the component .Thanks to all
- Attachments
-
- Capturar.PNG
- (173.48 KiB) Downloaded 1069 times
- Benj
- Matrix Staff
- Posts: 15312
- Joined: Mon Oct 16, 2006 10:48 am
- Location: Matrix TS Ltd
- Has thanked: 4803 times
- Been thanked: 4314 times
- Contact:
Re: EDIT THE COMPONENT KEYPAD
Hello,
This is not currently supported by the component. We can look to add it to the latest version but it's unlikely we will add the functionality for Flowcode 6.
You could always create your own macro routine for scanning for key presses to allow for the inverted polarity. You could also use an inverted buffer IC to flip the signals going back to the microcontroller.
This is not currently supported by the component. We can look to add it to the latest version but it's unlikely we will add the functionality for Flowcode 6.
You could always create your own macro routine for scanning for key presses to allow for the inverted polarity. You could also use an inverted buffer IC to flip the signals going back to the microcontroller.
Regards Ben Rowland - MatrixTSL
Flowcode Product Page - Flowcode Help Wiki - Flowcode Examples - Flowcode Blog - Flowcode Course - My YouTube Channel
Flowcode Product Page - Flowcode Help Wiki - Flowcode Examples - Flowcode Blog - Flowcode Course - My YouTube Channel
-
- Posts: 150
- Joined: Mon Oct 15, 2012 5:19 pm
- Has thanked: 12 times
- Been thanked: 18 times
- Contact:
Re: EDIT THE COMPONENT KEYPAD
Hello Benj thank you for answer me.In that case I create a macro to make a positive sweep.