From: Tony Perry
Hi Benj,
I am using the EB006 with the HP299. It works well. I do have one small problem. My PC indicates that it sometimes doesn't recognise the hardware, even half way through a simulation. Simply unplugging the USA & plugging it in again mostly fixes the problem. Have you seen this before. Its almost as if the link fails sometimes.
Regards
Tony Perry
USB Link Failure
Moderator: Benj
- Benj
- Matrix Staff
- Posts: 15312
- Joined: Mon Oct 16, 2006 10:48 am
- Location: Matrix TS Ltd
- Has thanked: 4803 times
- Been thanked: 4314 times
- Contact:
Re: USB Link Failure
Hi Tony,
Yes I have come across this problem. It normally occurs when there is load on either the USB out connector or the ICD/Scope connectors which means for some reason the USB chip does not start up correctly and register itself on the PC. If your struggling to get it to work then unplugging all cables from the Flowkit and then replugging starting with the USB from the PC should allow it to work correctly every time.
Yes I have come across this problem. It normally occurs when there is load on either the USB out connector or the ICD/Scope connectors which means for some reason the USB chip does not start up correctly and register itself on the PC. If your struggling to get it to work then unplugging all cables from the Flowkit and then replugging starting with the USB from the PC should allow it to work correctly every time.
Regards Ben Rowland - MatrixTSL
Flowcode Product Page - Flowcode Help Wiki - Flowcode Examples - Flowcode Blog - Flowcode Course - My YouTube Channel
Flowcode Product Page - Flowcode Help Wiki - Flowcode Examples - Flowcode Blog - Flowcode Course - My YouTube Channel