Hello
I have a SSD1351 OLED display that i would like to use (datasheet indicates 4 wire SPI connections)
SDIN / SCLK / CS / DC / RES
serial in / serial clock / chip select / data..command / reset
1. Looking at the graphic display component from FC6 "SSD1351" i am not sure if it
uses hardware SPI or software driven pins (selectable in properties)?
2. In the properties....does the "Register Select (RS)" mean to be attached to the DC (data...command)
pin of the display?
I have connected the display to the hardware SPI (18F46K22) but not sure the macro component will work
like that....and what to do about the "Register Select" in the properties of the macro component (SSD1351)
Thanks
Mark
SSD1351 Componet
Moderator: Benj
- Benj
- Matrix Staff
- Posts: 15312
- Joined: Mon Oct 16, 2006 10:48 am
- Location: Matrix TS Ltd
- Has thanked: 4803 times
- Been thanked: 4314 times
- Contact:
Re: SSD1351 Componet
Hello Mark,
Let us know how you get on.
Currently the component uses software (bit banged) SPI.1. Looking at the graphic display component from FC6 "SSD1351" i am not sure if it
uses hardware SPI or software driven pins (selectable in properties)?
Yes the RS and DC are effectively two names for the same pin and can be connected.2. In the properties....does the "Register Select (RS)" mean to be attached to the DC (data...command)
pin of the display?
Let us know how you get on.
Regards Ben Rowland - MatrixTSL
Flowcode Product Page - Flowcode Help Wiki - Flowcode Examples - Flowcode Blog - Flowcode Course - My YouTube Channel
Flowcode Product Page - Flowcode Help Wiki - Flowcode Examples - Flowcode Blog - Flowcode Course - My YouTube Channel