Hi,
I am ready to program my first PIC. I have flowcode Pro V3.1.0.31, is this the latest?
I have an MPLAB ICD2 USB clone programmer.
Since I do not have PPP for the programmer can someone provide me with the proper steps to use MPLAB 7.6.
This is what I think I need to do.
1. in flowcode select 16F886 as target.
2. write the program.
3. compile to ASM.
4. Run MPLAB 7.6
5. Select device 16F886
6. Programmer - select programmer - MPLAB ICD2
7. File - import - select flowcode hex file
8. set the configuration bits <- Can this be done in flowcode?
9. put chip in programmer
10. Programmer - select connect
11. programmer - select program
12. wait until done programming.
Have I missed anything or is one or more steps wrong?
Thanks
Ron
16F886
- Steve
- Matrix Staff
- Posts: 3424
- Joined: Tue Jan 03, 2006 3:59 pm
- Has thanked: 114 times
- Been thanked: 422 times
- Contact:
v3.1.0 is the latest.
You should be able to enter the configuration bits into Flowcode - either by "Chip...configure" or entering the suitable 'C' pragma commands into the "defines" section of the "supplementary code" window. This data will then get stored into the HEX file when it is created by Flowcode.
You should be able to enter the configuration bits into Flowcode - either by "Chip...configure" or entering the suitable 'C' pragma commands into the "defines" section of the "supplementary code" window. This data will then get stored into the HEX file when it is created by Flowcode.
- Benj
- Matrix Staff
- Posts: 15312
- Joined: Mon Oct 16, 2006 10:48 am
- Location: Matrix TS Ltd
- Has thanked: 4803 times
- Been thanked: 4314 times
- Contact:
Hello Ron
Yes that should about cover it.
You also should be able to set the configuration bits in Flowcode.
Also you should probably have a verification at the end of programming to make sure the code on the PICmicro is correct.
Yes that should about cover it.
You also should be able to set the configuration bits in Flowcode.
Also you should probably have a verification at the end of programming to make sure the code on the PICmicro is correct.
Regards Ben Rowland - MatrixTSL
Flowcode Product Page - Flowcode Help Wiki - Flowcode Examples - Flowcode Blog - Flowcode Course - My YouTube Channel
Flowcode Product Page - Flowcode Help Wiki - Flowcode Examples - Flowcode Blog - Flowcode Course - My YouTube Channel