Hello, I'd like to purchase a license to run code on Arduino hardware. I understand that I could buy some AVR chips and burn the Arduino bootloader on them. My confusion is about the two Flowcode chip licenses; do I really need to buy both licences or do I get a discount if I buy both AVR and Arduino? I'm not sure which direction to go.
I currently have PIC 8 and Raspberry PI licenses. I would like to get another license for PIC32 and ARM someday.
I understand that the more licenses I have, the larger the upgrade license cost will be. Does it make sense to just get the AVR license and blow away the arduino bootloader when programming? I have a Pickit 4 and I believe support for AVR programming is forthcoming.
Dan
Question about Flowcode chip license: Arduino vs ARM
Moderator: Benj
Re: Question about Flowcode chip license: Arduino vs ARM
Anyone have any thoughts? Does the Arduino chip pack get me anything over and above the AVR chip pack? It just seems like the AVR chip pack would be more flexible than the Arduino chip pack.
- Benj
- Matrix Staff
- Posts: 15312
- Joined: Mon Oct 16, 2006 10:48 am
- Location: Matrix TS Ltd
- Has thanked: 4803 times
- Been thanked: 4314 times
- Contact:
Re: Question about Flowcode chip license: Arduino vs ARM
Hello,
The AVR chip pack requires a programming tool such as the usb tiny. The Arduino chip pack is aimed at programing via the bootloader.
If you think you may use the chips in the future over an Arduino board then yes the AVR chip pack would make more sense, has more available target devices and will allow you to program Arduino devices too. Though the initial setup maybe slightly more tricky. E.g. you have additional config settings to consider.
You can always buy additional chip packs in the future should you find you need them.
Hope this helps.
The AVR chip pack requires a programming tool such as the usb tiny. The Arduino chip pack is aimed at programing via the bootloader.
If you think you may use the chips in the future over an Arduino board then yes the AVR chip pack would make more sense, has more available target devices and will allow you to program Arduino devices too. Though the initial setup maybe slightly more tricky. E.g. you have additional config settings to consider.
You can always buy additional chip packs in the future should you find you need them.
Hope this helps.
Regards Ben Rowland - MatrixTSL
Flowcode Product Page - Flowcode Help Wiki - Flowcode Examples - Flowcode Blog - Flowcode Course - My YouTube Channel
Flowcode Product Page - Flowcode Help Wiki - Flowcode Examples - Flowcode Blog - Flowcode Course - My YouTube Channel
- Steve
- Matrix Staff
- Posts: 3422
- Joined: Tue Jan 03, 2006 3:59 pm
- Has thanked: 114 times
- Been thanked: 422 times
- Contact:
Re: Question about Flowcode chip license: Arduino vs ARM
When it comes to upgrading, you are not forced to upgrade very aspect of Flowcode. So it would only be more expensive if you chose to upgrade all of your features and chip-packs.dmann wrote:I understand that the more licenses I have, the larger the upgrade license cost will be.Dan