Hi MM!
I think there are a bug in the component for the GLCD_SSD1963. If I add it to one of the dashboard and I try to zoom with mouse, it have a strange behavior. I get a lot of dots on the board.
apologize if I am doing something wrong.
Br Jorgen
glcd_ssd1963
Moderator: Benj
-
- Posts: 1333
- Joined: Tue Oct 06, 2009 9:39 am
- Has thanked: 1135 times
- Been thanked: 299 times
- Contact:
- Benj
- Matrix Staff
- Posts: 15312
- Joined: Mon Oct 16, 2006 10:48 am
- Location: Matrix TS Ltd
- Has thanked: 4803 times
- Been thanked: 4314 times
- Contact:
Re: glcd_ssd1963
Hi Jorgen,
There are two simulation modes for graphical LCDs available via the component properties. The point cloud simulation mode is made up of dots, if you change this to bitmap mode then it should draw as expected. There may be a problem using the bitmap simulation mode on larger displays e.g. it might run a lot slower.
There are two simulation modes for graphical LCDs available via the component properties. The point cloud simulation mode is made up of dots, if you change this to bitmap mode then it should draw as expected. There may be a problem using the bitmap simulation mode on larger displays e.g. it might run a lot slower.
Regards Ben Rowland - MatrixTSL
Flowcode Product Page - Flowcode Help Wiki - Flowcode Examples - Flowcode Blog - Flowcode Course - My YouTube Channel
Flowcode Product Page - Flowcode Help Wiki - Flowcode Examples - Flowcode Blog - Flowcode Course - My YouTube Channel
-
- Posts: 1333
- Joined: Tue Oct 06, 2009 9:39 am
- Has thanked: 1135 times
- Been thanked: 299 times
- Contact: