Hi,
Is there a reason why program device EB006 supports far fewer devices than flow code? Will more devices be supported by program device EB006 in the near future?
supported diveces EB006
-
- Valued Contributor
- Posts: 2045
- Joined: Wed Aug 27, 2008 10:31 pm
- Location: Netherlands
- Has thanked: 553 times
- Been thanked: 1081 times
- Contact:
Re: supported diveces EB006
The EB006 can only support devices where pins are at a defined position (power, OSC, reset and I/O ports). The software can support devices regardless where the pins are located on the physical package.
“Integrity is doing the right thing, even when no one is watching.”
― C.S. Lewis
― C.S. Lewis
- Steve001
- Valued Contributor
- Posts: 1189
- Joined: Wed Dec 31, 2008 3:37 pm
- Has thanked: 460 times
- Been thanked: 523 times
- Contact:
Re: supported diveces EB006
Hi Werner LJ
If you have a EB006 V9 programming Board
Then you can connect a pickit 3 via the adaptor lead that is available from microchip and program more devices via ICSP (after moving the links on the board)
I am not sure if the "GHOST" feature works on devices that are not on the device list - matrix will be able to confirm this.
https://www.microchipdirect.com/product ... l/TPROG001
I am using this method with no problems experienced to date
Steve
If you have a EB006 V9 programming Board
Then you can connect a pickit 3 via the adaptor lead that is available from microchip and program more devices via ICSP (after moving the links on the board)
I am not sure if the "GHOST" feature works on devices that are not on the device list - matrix will be able to confirm this.
https://www.microchipdirect.com/product ... l/TPROG001
I am using this method with no problems experienced to date
Steve
- Attachments
-
- 20171126_081215.jpg (69.35 KiB) Viewed 4317 times
Success always occurs in private and failure in full view.
- Benj
- Matrix Staff
- Posts: 15312
- Joined: Mon Oct 16, 2006 10:48 am
- Location: Matrix TS Ltd
- Has thanked: 4803 times
- Been thanked: 4314 times
- Contact:
Re: supported diveces EB006
On the newer PIC devices the programming scheme changes completely. The EB006 firmware doesn't support the new programming scheme.Is there a reason why program device EB006 supports far fewer devices than flow code? Will more devices be supported by program device EB006 in the near future?
Yes Ghost will work fine. For ICD to work you need the programming jumper in the USB position.I am not sure if the "GHOST" feature works on devices that are not on the device list - matrix will be able to confirm this.
Regards Ben Rowland - MatrixTSL
Flowcode Product Page - Flowcode Help Wiki - Flowcode Examples - Flowcode Blog - Flowcode Course - My YouTube Channel
Flowcode Product Page - Flowcode Help Wiki - Flowcode Examples - Flowcode Blog - Flowcode Course - My YouTube Channel