EBM018 Colour Sensor Module

Tips, Tricks and methods for programming, learn ways of making your programming life easier, and share your knowledge with others.

Moderators: Benj, Mods

Post Reply
User avatar
medelec35
Valued Contributor
Valued Contributor
Posts: 8873
Joined: Sat May 05, 2007 2:27 pm
Location: Northamptonshire, UK
Contact:

EBM018 Colour Sensor Module

Post by medelec35 »

Equipment required:
EBM Colour Sensor Module plugged on (either way around) to S1 of EB090
EB090 Mother board connected to port B of EB006 PICmicro multiprogrammer.
EB006 PICmicro multiprogrammer with PIC16F1937 microcontroller.
EB007 push-to-make switch board connected to port A of EB006 PICmicro multiprogrammer. (only using SW5 = RA5)
EB005 LCD board connected to port C of EB006 PICmicro multiprogrammer.
PSU suitable for EB006 PICmicro multiprogrammer. (9V for EB006V8 and greater, 12-14V for EB006V7 or earlier)
Flowcode V6 Home or above.

At the time of writing, EBM018 Colour Sensor Module is available for £13.50 + Vat
You will also require a Sensor board(EB090) which is a mother board for the EBM sensors Range
The Mother board must have two supplies connected to it.
+5V for +V & +9 to 14V (depening on PICmicro multiprogrammer version) connected to VPWR
The Flowchart including all simulation components used was originally created LeighM, Steve M and Paul so they deserve most of the credit.
I have modified it in order to add some improvements.
1) Added Automatic (default ) or manual mode
2) Added a count down to sample timer:
simulation.png
(101.63 KiB) Downloaded 7934 times
When power is first applied, hardware is in automatic mode.
So the white LED's on the sensor will light, LCD will show the time counting down to end of sample readings, LED's will go out then LCD will display Red, Green & Blue values of sample.
After 3 seconds has elapsed the process is repeated all over again automatically.

If you hold SW5 (long press mode for about a second) down until LCD will show Manual Mode, then every time you press and release SW5 (Short press) a sample will be taken the same as it is in automatic mode.
However after the countdown has finished the R, G & B values will remain until SW5 is short pressed again.
Every time you long press SW5 mode will change.

Note:
If you run the simulation, then since interrupt is running extremely fast then you may not see the seconds counting down.
Attachments
EBM018_-_Test_Program V2.fcfx
(22.89 KiB) Downloaded 511 times
Martin

If you read a post that is useful, please show appreciation by clicking on thumbs up Icon.

kalmar79
Posts: 45
Joined: Sun Aug 20, 2017 8:18 pm
Contact:

Re: EBM018 Colour Sensor Module

Post by kalmar79 »

My friend I want to practice with a colour sensor check this post please.


http://www.matrixtsl.com/mmforums/viewt ... 54&t=19317

User avatar
Benj
Matrix Staff
Posts: 14835
Joined: Mon Oct 16, 2006 10:48 am
Location: Matrix TS Ltd
Contact:

Re: EBM018 Colour Sensor Module

Post by Benj »

This is the right right sensor for you Kalmar.

Post Reply