How hard could it be to get it back to the FC6?CAN solution Teachers notes wrote:25.2.4 The Details dialog
As Masks and Filters are quite complex, so we have included a dialog that displays which Message
ID's will be accepted given the current mask and filter settings for that buffer. To open the Details
dialog click on the Details button on the RX Buffer tabs.
Figure 25.1 The dialog shows the Mask and Filters values, and the Message ID's that each Filter
will accept
If a Filter is not enabled then the text "Filter Disabled" will be shown instead. The Buffer RX1 dialog is
similar to the Buffer RX0 dialog shown above, but with boxes for the four filters on that buffer.
CAN bus filter selection easier
Moderator: Benj
Forum rules
Only feature requests will be considered here. General questions should not be posted in this forum.
Only feature requests will be considered here. General questions should not be posted in this forum.
-
- Posts: 444
- Joined: Tue Apr 15, 2014 4:19 pm
- Location: Kajaani, Finland
- Has thanked: 345 times
- Been thanked: 227 times
- Contact:
CAN bus filter selection easier
You had some kind of mask calculator in V4/V5?
Ill just keep the good work up!
- Benj
- Matrix Staff
- Posts: 15312
- Joined: Mon Oct 16, 2006 10:48 am
- Location: Matrix TS Ltd
- Has thanked: 4803 times
- Been thanked: 4314 times
- Contact:
Re: CAN bus filter selection easier
Thanks for the suggestion, I have added it to the list.
Regards Ben Rowland - MatrixTSL
Flowcode Product Page - Flowcode Help Wiki - Flowcode Examples - Flowcode Blog - Flowcode Course - My YouTube Channel
Flowcode Product Page - Flowcode Help Wiki - Flowcode Examples - Flowcode Blog - Flowcode Course - My YouTube Channel